FAQ

All Freggia products are produced on the leading industries in Europe.

All accessories You can buy in retail outlets or inernet shops. Full list of outlets you can find in the section "Where to Buy "

After the hob's installation the plates must be operated for 5 minutes at full power, without any pan. So turn them off and let cool.
During this operation will happen the emission of smoke, this is the proper procedure. This is due to humidity accumulated inside the hot plates and it will disappear with this operation. So it is not an appliance defect.

Every 10-15 times it is used, leave the oven empty at full heat. The time required for cleaning depends on the condition of the oven.
Some splashes tend to set hard and may clog the pores of the special coating, preventing oxidation and eliminating its self-cleaning properties. In this case, as soon as the oven has completely cooled apply very hot water to soften the deposits and use a soft brush, without detergent, to remove them. Then switch the oven back on at maximum heat for a few minutes.
Important: never use metal brushes or abrasive substances for cleaning catalytic panels.